Product no.: TTR-0085

The tab washers can only safely be used twice so don't forget to add one to your sprocket order!

£3.35 *

Still in stock

Accessories

Product no.: TTR-0087

Talon 13 tooth front sprocket.

Fit with boss inwards - facing toward the engine.

The sprocket nut needs a 30mm socket. Remove it BEFORE taking off the chain to make the job easier.

If there's a possibility the tab washer has been off more than once before you may need to order a new front sprocket tab washer TTR-0085 below

£14.50 *

Currently unavailable

Product no.: TTR-0088

Talon 14 tooth front sprocket.

Fit with boss inwards - facing toward the engine.

The sprocket nut needs a 30mm socket. Remove it BEFORE taking off the chain to make the job easier.

If there's a possibility the tab washer has been off more than once before you may need to order a new front sprocket tab washer TTR-0085 below

£14.50 *

Currently unavailable

Product no.: UNI-0001

 We only sell the Renthal Works 520 R3.3 O Ring . These have replaced the old R3 Chain.

After a lot of practical research on the roads and green lanes of Devon, these chains have proved to give exceptional service. Also fits Yamaha WR250R and WR250X models

It is a 118 link chain which fits all the combinations of TTR250, WR250R/X and WR250F sprockets that we sell although it will need some links taking out for smaller sprocket sets. This is easily done with a chain breaker. Guide to shortening a chain here.

This 520 o-ring chain is designed for the extreme rigours of off road use.

Brand: Renthal

NEW Renthal  Bike Chain 520 pitch R3.3 SRS O Ring 118 Links. Renthal R3 chains are specially developed utilising Renthal’s SRS technology to increase the service life.

The special SRS is pre-loaded during assembly, creating a spring effect. As a chain wears, conventional O-rings and X-rings loosen their seal whereas the SRS has the inherent ability to regulate a constant sealing pressure against the side plates throughout the life of the chain.

The pack contains both a rivet (soft) and a split link plus rubber gloves and sticker.

NB The original chain and sprockets on a Raid are 428 so this chain will only fit if the sprockets are upgraded at the same time to match.

 

£80.00 *

In stock