Bar "spacer" risers - will fit all TTR250 models including the Raid.

A very simple modification that raises the bars by 6mm. This is the maximum possible whilst allowing the retaining locknuts to stay on the thread. These spacers have been made up especially for Totally TTRs.

The kit includes the two spacers as shown. Five minute install. No changes necessary in cables, etc. 

Raising your handlebars by even a small amount will make your bike more comfortable. If you feel awkward when standing, like you may fall forward if you touch the brakes, or if you feel like you are constantly leaning forward on the bars when riding straight and level, raising the handlebar height will make all the difference. The bike feels more controllable, standing or sitting.

This picture shows just one of the spacers fitted to demonstrate where they go and show how easy they are to fit.

The kit fits under the original bar mounts and also allows you to drop the fork legs up through the yokes by a further 6mm if you are trying to lower the front as shown on my own TTR in this picture.

Bar risers - Fits all TTR250 models including the Raid - but not Fatbars. Also fits Yamaha WR250R and WR250X models

Brand new risers made specifically for Yamaha Dirt and Dual Sport bikes with 7/8" handlebars 

The kit includes spacers needed to give a choice of 4 heights with appropriate longer sets of four stainless steel bolts

Five minute install - no changes necessary in cables, etc. 

Fits into the original bar mounts and allows you to raise the bars in increments of 5mm - 20mm, 25mm, 30mm and 35mm.

Raising your handlebars by even a small amount will make your bike more comfortable. If you feel awkward when standing, like you may fall forward if you touch the brakes, or if you feel like you are constantly leaning forward on the bars when riding straight and level, raising the handlebar height will make all the difference. The bike feels more controllable, standing or sitting. Saves lower back pains and aching wrists when riding!

Vennhill Replacement Clutch cable - extra length - fits ALL models and years of TTR250s

We have replacement top quality cables made up especially for Totally TTRs by Venhill.

Manufactured to give 150mm extra length to accommodate raised bars. 
A cheaper alternative to the standard Yamaha cables even if you are not using risers.

Fitting guide here.

Venhill's advice on installation and maintenance here: http://www.venhill.co.uk/content.asp?PageID=418&ThreadID=418