Product no.: TTR-0767

All Balls
Carburetor Repair Kit TTR 250

Here is what all balls say about the kits......

Type:   Rebuild Kit
Sold as:   Each
  • Kits include most of the components necessary to repair a carburetor: O-rings, gaskets, jets, needle, mixture screw, float bowl screws, float valve needle and seat.
  • Nitrile rubber material is used on all O-rings and rubber gaskets.
  • High performance Interface gasket material is used for all paper gasket applications.
  • OEM jet sizes are included in the kit.

Here is what I have added after some fitting issues.....

  • I have added 2 x Carb diaphragm O ring seals to the kits (not in the main picture) and the 2 screws for the diaphragm cover.
  • Correct fitting screws and locking washers x3 have been added to the All Balls kits, for the float bowl cover.
  • I have also supplied correct fitting O ring for the pilot screw, as the All Balls one is too small.

 

  • If your carb is leaking fuel at the bottom, you may also need to order a new diaphragm.
£35.00 *

In stock

Accessories

Product no.: TTR-0054

TTR250 - genuine new Yamaha carb stub - fits all TTR250 models

Carburettor inlet manifold (carb stub)

If you need a new O ring these are available in the shop

Carb_stub_new2

 

£55.00 *

Still in stock

Product no.: TTR-0042

Carburettor diaphragm - fits all TTR models including the Raid

Genuine Yamaha part. 

If you also need the two small O rings that sit alongside the diaphragm then we have some after-market Viton 75 ones in the shop.

To help get a good seal, make sure all corrosion etc is cleaned off the diaphragm cover before refitting. I rub the cover on a sheet of fine wet & dry paper on a dead flat surface to give it the best possible chance.

£41.50 *

In stock